How do we know what version our servers are running on for B

[nbtc971]

We have a 64 slot server that is always full. Even after a crash it fills up in about 3 minutes. So I'm not sure if you guys were ever able to update the server software to r5. Is there anyway to tell what version we're on in the control panel? I can't find anything. Or can you tell me if we've been updated if I tell you the server info?

It's on our managed dedicated: chicago-quad34-i-30, and the server IP is: 216.52.148.185

Thanks.

[Edge100x]

Use this command via the rcon tool to see your version:

Code: Select all

version

If it says 881071, you're running R5. Anything lower, and you're on R4.

[dapriest]

How do we get our servers on R4 to R5?

[nbtc971]

Both of ours are still r4. Our 64 slot server is full 24/7, hard to update it, but the 32 slot, not sure why it hasn't been updated yet.

[Edge100x]

nbtc971, if you requested R5 from us, we should have updated it. Did you request it?

Otherwise, we've been holding off, and we're glad we did, because of the major PB issues. With the PB problems resolved, we're going to start updating empty servers.

[nbtc971]

We did not request it. But the server just crashed again, 2nd time in 45 minutes.

[dapriest]

John I believe all new server deployments include the R5 version.

[.=QUACK=.Major.Pain]

We are still on R4 with no crashing at all, but we had a lot of rubberbanding with only 5-6 players on the server.